DAEWOO ELECTRONICS DF-4700P Technical Information PDF herunterladen (Seite 3)

Page 3-3

Using The System

Using The Remote Control

DIGITAL REMOTE TYPE: UHF OR IR

There are two types of Digital Remote Controls: Infrared (IR) or Ultra-high Frequency

(UHF). The UHF remote has the UHF symbol on it, as in the picture below. The IR

remote does not have the UHF symbol. The back of the IR remote has the words

“INFRARED REMOTE” on it.

ABOUT THE UHF REMOTE

The UHF remote sends ultra-high frequency radio signals to a UHF

antenna connected to the back panel of UHF compatible receivers.

With UHF compatible receivers, the signals will travel through solid

objects and allow you to use the remote to control the receiver from another room, or

even from another floor in the building, to a possible maximum of 30 metres away from

the receiver. To check if your receiver is UHF compatible, look for the UHF Remote

Antenna connection on the back panel of the receiver.

The UHF antenna must be attached to the receiver back panel UHF Remote Antenna

connection in order to use the UHF remote control. Because the UHF remote operates

from such a long range, the receiver may respond to signals from other nearby remote

controls. To handle this problem, see the Changing the Digital Remote Address

procedure on page 3-9. Because the UHF antenna is sensitive, it may pick up other UHF

signals, interfering with the operation of the remote. Try Changing the Data Base

Remote Address first. If this does not work, see Installing an Attenuator on page 3-11.

ABOUT THE IR REMOTE

The IR remote uses infrared light to control the receiver and has a maximum range of

40 feet. You must point the remote directly at the receiver, with no solid objects in the

way.

Do NOT change the address of an IR Remote. The IR Remote Control is programmed

to control the satellite receiver when packaged. Unless you have two receivers in the

same room, you should not need to change the address. If you have two receivers in the

same room and the remote is controlling both, perform the Changing the Digital Remote

Address procedure on page 3-9 to change the address of the remote to specifically

control one satellite receiver.

1 2 3 4 5 6 7 8 ... 55 56

Keine Kommentare

DAEWOO ELECTRONICS DF-4700P Technical Information Seite 3