DAEWOO ELECTRONICS DF-4700P Technical Information PDF herunterladen (Seite 9)

Page 3-9

Using The System

Using The Remote Control

CONTROLLING THE SOUND VOLUME USING THE

REMOTE CONTROL

When you first get the system, it is set up so that the receiver remote can

control the sound volume.

Note: The TV remote can also control the sound volume. If you turn down or mute the

sound volume using the TV remote, the receiver remote control cannot turn the volume

back up.

To change the sound volume, do the following:

• Press the Volume button on the receiver remote control, or

• Press the volume control button on the TV remote control.

CHANGING THE DATA BASE REMOTE ADDRESS

The Remote Control is programmed to control the satellite receiver when packaged.

Unless you have two receivers in the same room, you should NOT change the address.

Do not change the address of an IR remote unless absolutely necessary. See About the IR

Remote on page 3-3. Note: If you start this procedure and at any time do not press a

button within 20 seconds, the remote will end the procedure automatically. Simply start

over again. If necessary, do the following procedure to change the address of the remote

to specifically control one satellite receiver:

1. Press the Menu button on the remote control to display the Main menu.

2. Select the System Setup option to display the System Setup menu.

3. Select the Installation option. This displays the Installation and Setup menu.

4. Select the System Info option. Note the number in the Remote Address field.

5. Press and hold the SAT button (about three seconds) until all mode key backlights

come on, then release. The SAT key backlight will flash to indicate it is in the address

programming format.

6. Use the number pad buttons to enter a number from 1 to 15. The light will blink off

after each digit is entered and then return to a steady light.

7. Press the # button. If the code you entered is valid for the remote, the SAT mode light

blinks three times.

8. Press the Record button. The number in the Remote Address field should match the

one you input.

9. To verify the code, press the SAT mode button for 3 seconds. The light will blink

back on. Press the pound (#) button twice. The light will flash the address number.

10.Select Cancel to exit.

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 55 56

Keine Kommentare

DAEWOO ELECTRONICS DF-4700P Technical Information Seite 9