Using The System
Using The Remote Control
Page 3-5
POWER
In SAT mode, press the Power button to turn the receiver ON or
OFF. The green power light on the receiver front panel lights up to
indicate the receiver is ON. For each mode, the Power button will
turn that device on and off. Note: You must program the remote for
that device. See Programming the Remote to Control Other Devices
on page 3-10.
PAGE UP OR DOWN ARROWS
In SAT mode, press the Page Up or Page Down arrow to scan,
by page, through the listing of channels when you have the Program
Guide open or, if your receiver supports Themes, the Theme
Categories menu opens.
In VCR mode, these arrows move up or down through the television
channels.
MUTE
In any mode, press the Mute button to temporarily turn off the
sound. Press it again to restore the sound. The Mute button works
only if you have programmed the remote. See “Programming the
Remote to Control Other Devices” on page 3-10. If, after
programming the remote, you still cannot turn up the volume, your
receiver may have its own volume. Try one of the following:
• Pull the Smart Card out of the slot on your receiver front panel.
Wait about 5 seconds, re-insert the card, and try turning up the
volume. Or,
• Using the Programming the Remote to Control Other Devices
procedure in SAT, TV, or VCR mode, the code 222 will program
the remote to control the sound volume in some satellite receiver.
Note: To control your TV, you will need to reprogram the remote
back to the code that works for your particular TV.
VOLUME
In any mode, press the plus (+) side of the Volume button to increase
the sound volume. Press the minus (-) side of the Volume button to
reduce the sound volume. This button works only if you have
programmed the remote. See “Programming the Remote to Control
Other Devices” on page 3-10. If, after programming the remote, you
still cannot turn up the volume, your receiver may have its own
volume. Try one of the procedures described under Mute.
Kommentare zu diesen Handbüchern